|
Farmall & IHC Tractors Discussion Board |
PTO fluid?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MWKellner on March 19, 2001 at 12:08:31 from (168.171.27.5):
I took the belt pulley assembly (the one that would run a stationary gristmill) off the back of 1953 Super C in order to install 3 pt. hitch kit, and almost NO oil ran out (about 1/2 cup). My question is was that gear housing suposed to be full of oil? Does this mean that the whole PTO system would be low on oil? What kind of fluid should go in there? I suppose that I should check this out before I run the PTO under load. Thank you so much for your help. -- Martin
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|