Overhauling SM liftall

Posted by Joe Berendzen on March 11, 2001 at 17:58:20 from (216.152.11.93):

While I have my liftall out, I've got it apart and have found one of the valve balls is pitted somewhat from rust. I assume that this has been causing some of my problem with the three point hitch bleeding down. Maybe the cylinder needs a kit too? Anyway, the IT manual says to use a ball 1/32 inch larger to lap the ball seat. I measured the ball I took out, and as best I can tell, It's a 3/4 inch ball. I went to the local bearing distributor to get a new replacement ball and the larger one, but they can't get individual balls. Any leads on where I can get the right size balls? Of course I write this on Sunday without first calling the local Case/IH dealer first. What can I say? I love this website!

Follow Ups:

• Re: Overhauling SM liftall Phlogiston 18:49:43 03/11/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Overhauling SM liftall Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]