|
Farmall & IHC Tractors Discussion Board |
PTO over haul on a Farmall 300
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gibby on March 07, 2001 at 07:23:17 from (198.144.79.24):
Looking for words of wisdom as I prepare to over haul my Farmall 300 High Crop PTO. It is working fine right now, but the main purpose (long term) I have for this tractor is to drive a 25KVA PTO Generator and a Brush Hog. That will take all 40 HP's at the PTO to drive the Generator and I figure after 44 years of service, it may need a "tune up". The band adjusters are below 3/8's of a inch from the top of the locking nut. I would prefer to replace the needed maintenace parts - versus chewing it up the first time I need it to really work. I have my shop manual and it seems straight forward to replace the bands, what other parts are commonly worn out and need replaced, I'd like to get most of the common parts up front - lessen my down time now that we have a cold spell again. Thoughts - suggestions - words of advise - prayers.... Source for parts? Thanks Dave
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|