|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall H Governor questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick Davis on March 06, 2001 at 18:10:39 from (64.12.102.181):
In Reply to: Re: Re: Farmall H Governor questions posted by Catless, OOPS on March 06, 2001 at 16:15:07:
Charlie, yes the idle rpms screw has been set.
Bob M, I did that step and your explanation did make sense ( the pin went right in!) - I may recheck that again if I don't get anymore suggestions.
Dead H, I did put a kit in the carburator but that shaft wasn't replaced, I'll verify the carb/gov connecton is correct. Thanks for the ideas, keep them comming. D-2
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
