Farmall & IHC Tractors Discussion Board |
Re: special use of Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by S-E Michigan Part Timer on February 23, 2001 at 10:33:09 from (209.176.108.195):
In Reply to: special use of Farmall M posted by John on February 23, 2001 at 07:44:09:
Think someone had a similar question a few weeks back. First, the M won't likely have a 3 pt hitch. Also consider, unless you have a SM, it wont' have live pto. Last, the hydro control valve (normally) is located near the front of the tractor.. Not in reach of someone operating from the rear on the ground. And last, since you get on and off of an M from the rear, take into consideration the safety issue that you probably wouldn't have from one of it's newer cousins, such as a 460U..
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|