|
Farmall & IHC Tractors Discussion Board |
Re: Loader for SM
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john d on February 06, 2001 at 05:24:58 from (206.141.74.34):
In Reply to: Loader for SM posted by KEITH on February 05, 2001 at 17:55:29:
I've got a row-crop M and SM on which I've used a loader for years. The narrow front is no problem as long as.....you keep some very simple rules in mind: 1) Keep the load low except when you MUST raise it high. When the load is high, don't turn! 2) Go slow, especially when turning. 3) Keep the load centered on the loader. 4) Do not make sudden, jerky moves with the steering or clutch. 5) Know the terrain - avoid holes, rocks, or hillsides that will upset the balance of the tractor. 6) NEVER let anyone ride in the bucket. You'll also find that power steering is a big assist. Keep the front tire pressure at 35psi or so, and enjoy the additional versatility of your tractor.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|