|
Farmall & IHC Tractors Discussion Board |
Re: Re: OK boys, pick a side
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Daniel C. on February 03, 2001 at 19:25:40 from (63.238.237.19):
In Reply to: Re: OK boys, pick a side posted by A JOHN DEERE WILL PULL THEM ALL on February 03, 2001 at 15:19:40:
You Junk Deere guys just wish thats what the IHs could pull. I heard a good story not to long ago. A guy to a F-30 to a tractor pull. Two guys just got done pulling two 4230 John Deeres. They made it about half way. The guy with the F-30 hooked up and pulled the sled out. The John Deere guys never pulled again because that F-30 beat them. Another one. A guy had an M strait off the farm. 6 4020s and 2 3020s pulled before he did. They didn't make it to the full pull mark. The guy with the M hooked up to the sled and pulled it out. That must have been real embarrasing for you JD guys. I have read and heard that the new Case IH tractors are alot better that the new JDs anyways. I believe it. My grandfather has a 4020 and a 3020 that we used to farm with. Talk about pieces of junk. Everytime we needed them they wouldn't start or we would have to work on them. We replaced them with a Farmall 806 and 856. We also used older Farmalls to replace them. Any of our IHs would run circles around those Junk Deeres.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|