Farmall & IHC Tractors Discussion Board |
Re: Super C Farmall Block Casting
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Redbarron on February 01, 2001 at 16:11:38 from (209.195.147.2):
In Reply to: Super C Farmall Block Casting posted by John W. Rousset on February 01, 2001 at 13:28:28:
HI John I also have a 1951 Super C that has the same thing cast into the block. This was Posted before. and a guy by the name of Ed Fisher replied that he has a Super A with the same thing. Did you have the engine torn down?? I completly rebuild mine. It is a 123 cu.in With 3 1/4 in. bore and the cam is not standard. I think the cam is out of a 340 farmall,but not sure. GO to the archives and you can read the discussions from before.I hope this helps. I have tried to find info.for a long time. I know one thing for sure my Super C runs & pulls real strong. we know there is three in the country,maby we will hear about some more. Luck RD
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|