|
| |
My project & Friend
Antique Tractor
 | | Behold! Here is a photo of my 1974 Dynamark tractor and a AMF tractor. The tranny was rebuilt a few years ago and with only a few hours work, the engine threw a rod. Dad replaced the Dynamark with the AMF. Having found another 8-hp Briggs and rebuilt it. I also rebuilt the electric starter. The rear wheel bearings were also replaced, as well as the transmission tension spring and the ignition switch. I am adding the pull-start to the Briggs Stratton engine. The original mower deck was replaced with a 36-inch deck off a Ford/Jacobsen tractor. I am trying to rebuild the fuel gauge. At present, I need to rewire the electical system, install the engine and finish the fuel gauge. If anyone wants to exchange information this and similar tractors, mail me a [email protected]. Submitted by Curle, Colin D, from Mb |
Home
| Forums
| Order Support
Today's Featured Article -
A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
