(800) 853-2651
SHOP NOW

Harris Ferguson TO35

R

RudyG

New User
I am trying to fix my HF, the hydraulic pump control valve. Top cover is off, side covers off, and I unbolted the bottom plate. I pulled the PTO shaft out about 3 inches, but I can't get anything apart any further. Or back together again for that matter. How does the pump detach from the bottom plate? And how do I get the shaft to go back thru the pump? the pump hits the brace on the front of the case but the shaft won't go far enough to engage the tranny.

Thanks for the help in advance.
 
if it's the same as a to30 the pump is part of the bottom plate, you have to fully remove the pto shaft and pull the plate towards the rear and down,..
 
Thanks, and therein lies the problem. I can't seem to extract the PTO shaft from the case. The shaft pulled out about three inches and stopped. like the cams on the pump are keeping it from coming out any further. I bolted the base cover back into position but the shaft will not slide in or out. I was reading some of the strings and I guess that there are a couple of dowels I have to remove? I'll be glad when I get my manual.
 
another thought, if it's the same as to30...mine had a twisted pto spline, had to cut the pto shaft to get pump out,...not as hard as it sounds but still a pain,...if that's your prob. let me know and i'll tell you what i did....
 
You must log in or register to reply here.

Similar threads

H
2030 water pump
Replies
10
Views
383
buickanddeere
B
S
Massey Ferguson 1080
Replies
3
Views
341
Dieseltech
D
J
178 Massey Ferguson Lift Arm Control - Won't go down
Replies
0
Views
193
JSJones
J
R
Clutch Stuck JD 3010
Replies
10
Views
575
Rick3
R
8
John Deere AR Governor Drive Problem
Replies
3
Views
307
8e3k0
8
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top