(800) 853-2651
SHOP NOW

OC 46 need pins and bushing turned in southern michigan

K

karl0532

New User
hello,
I have a OC46 with street grousers [11 inch] and wanted to get them turned locally if possible (shipping cost is excessive]. The local Cat dealer will do them but requires the grousers to come off. Since they are riveted on, I do not want to do this. Any ideas where I can get them done locally? If not, they're off to Zimmermans.
thanks for any help.
 
Can you be a little more specific, I am a toolmaker/machinist and I live in Southern Mi, near Flint. How big of a diameter are the pins and bushings? How many of each.?
 
I don't know who has a smaller track press in Michigan, but there must be somebody closer then 700 - 800 miles away? With a small press, it's no problem turning pins and bushings the pads on. I've done many HG/0C3 tracks on a smaller OTC press. Also Deere 420, 1010, etc.

Nothing wrong with using Zimmermans; they give great service. Just the distance, handling, and shipping I'm thinking about.
 
I would get on the internet there must be someone out there closer. My Dad's cousin turned the pins and bushings by hand with a sludge hammer. Not sure of the tractor I he had a HD5. I can hardly get my master pin out. stan
 
You must log in or register to reply here.

Similar threads

A
Need advice 2N purchase
2
Replies
27
Views
3K
Caryc
C
S
Tips and advice on a D4c
Replies
2
Views
1K
dpendzic
D
L
Lincoln VS Hobart Welding Schools, my future plans, and more
2 3
Replies
48
Views
10K
djrockytharp
D
J
Air condtioning problem NOT a tractor, but . . .
Replies
12
Views
3K
JDemaris
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top