plumbing a heater

Icuby · Nov 3, 2009

Installed a cab [QI-1---lookes like a heniker]on a IH 1256. I need to know where I install heater hose fittings so that the coolant will circulate right. Thanks

the tractor vet · Nov 3, 2009

On the left side of the engine there is a place to tap in on the oil cooler for the return and for the HOT there is a place up by the thermostat for the hot

buickanddeere · Nov 3, 2009

Main thing is to get the supply from the pressure side of the system just prior to the thermostat.
The heater return has to be on the suction side of the water pump/rad outlet. Sometimes there is pipe plug right on the pump inlet.

Icuby · Nov 3, 2009

So does it make a difference how it is hooked to the heater core? Thanks

Lou from Wi. · Nov 3, 2009

Buck7deer has the right awnser. LOU

Owen Aaland · Nov 4, 2009

If you do not find any other handy places you can add a T fitting where the coolant sensor is for the supply and run the return into the radiator drain.

plumbing a heater

Icuby

Member

the tractor vet

Well-known Member

buickanddeere

Well-known Member

Icuby

Member

Lou from Wi.

Well-known Member

Owen Aaland

Well-known Member

Similar threads