(800) 853-2651
SHOP NOW

1959 Massey 35 Utility

A

Al Bramley

New User
I need to change the water pump on this old girl!
Conty 4 banger gas engine, have a pump on its way, but Im not sure whats invloved in changing, doesnt look to tough but any help would ge great!
Thanks
Al
 
The I&T manual covers that adequately.

Take the fan blade off, the fan belt off. The upper hose off, three or four bolts and you have the water pump loose. Put it all back. You might have to press the pulley off and on or its flange, depending on who rebuilt or made the replacement pump.

Gerald J.
 
Implements and Tractors Publishing Company. Runs about $22 at farm stores or on line for several tractors per volume. Its a decent basic repair manual, poor on daily maintenance, not nearly as good as the factory shop manuals which are 50 times as thick and the factor parts books which are as thick as the factory shop manuals. Probably all are available from this YT site.

Gerald J.
 
Thanks again Gerald, got the new pump, got the old pump out, is there a special trick to pressing/ heating the pulley on and off?
tks
Al
 
I don't remember and the I&T book says nothing. But looking at the pictures: After you take off the conical pulley shroud, there is the pulley with a flange. To get it off the old pump you need to support the flange and push the shaft out with a hydraulic press. No heat, no banging. Then when you push the pulley on the new pump, you need to support the other end of the shaft. You don't want to push against the bearings or the casting. They most certainly will break. Be sure to note the clearance between the pulley and the pump, better the pump mounting surface so you push to the right place. If you don't have a hydraulic press, a good engine or farm machinery repair shop will have one and be practiced in changing water pump pulleys for a few bucks.

Even wrong color shops can do it.

Gerald J.
 
You must log in or register to reply here.

Similar threads

2
Massey Ferguson 1959 oil / filter and knocking
Replies
10
Views
501
2thmkr
2
J
Massey Ferguson 35 - Hydraulic Arms Not working
Replies
4
Views
513
jccox3
J
C
Massey Ferguson TO 35 Water Pump but alternator in way
Replies
1
Views
597
Jim.ME
J
F
Massey Harris 444 Exhaust Valve Seat Inserts
Replies
5
Views
373
FarmerHR
F
D
cant keep "D" running
2
Replies
25
Views
2K
Dr. CHIP
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top