Where Can I Find One?

TreeFarmer1414 · Jul 21, 2009

I am trying to find the wooden protector that came with sickles years ago for mowers by protecting the sickle sections (and your fingers) during shipping and handling. A six foot piece would be just right for my use. Any ideas where to look? In baseball jargon, going to the local dealer is a strike out. Thanks in advance for any help.

GeneMO · Jul 21, 2009

Probably be about as easy to take two pieces of 1X4, a spacer and some deck screws. once built, then tape, wire, or in some way secore it. I would baling wire it in place.

Gene

amo · Jul 22, 2009

I have seen a ridge cap from metal roofing used for this purpose. The one on 5 v crimp or the one from corrugated and just punch some holes and support it with a piece of wire. Good lucj.

armand tatro · Jul 22, 2009

Why not take a place of 4in. plastic drain tile and cut it so that it will fit over the sickle or cutter bar and tie it in place. Lite weight and will not rot. That what I did to protect the cutter bar on my mowing machine. If you just want to protect the sickle slide it into a solid plastic pipe and cap both ends. Armand

Where Can I Find One?

TreeFarmer1414

Member

GeneMO

Well-known Member

amo

Member

armand tatro

Well-known Member

Similar threads