Woods mower

Russ from MN · Dec 27, 2008

I am trying to get one of the arbor assembies apart, once removing the roll pin in the top sleve shoudnt it press out the bottom? Thanks in advace, Russ

John B. · Dec 27, 2008

Are you talking about the blade spindle assembly?
If so they are only a little over a $100 dollars. I've replaced quite a few of them on woods belly mowers, such as the L59, L306 etc.

you get the shaft with bearings and housing already assembled. Just bolt it to the deck and install your blade then you're ready to go. Can't beat it. Don't waste your time trying to take it apart.

Russ from MN · Dec 28, 2008

Thanks, got it apart, but not without breaking the flange on the housing, it may of been cracked before. There was a good drawing on Woods website and it pressed apart like I thought, just harder because of the roll pin driven only part way thru, I need a complete assy. anyhow because the shaft is bent on this one. Thanks.

Woods mower

Russ from MN

Well-known Member

John B.

Well-known Member

Russ from MN

Well-known Member

Similar threads