(800) 853-2651
SHOP NOW

Case dc4

M

Matt Agnel

Member
Dear lads
I just replaced the engine rings and all the gaskets on my Case Dc 4 and now the tractor does not want to run I hade it running for about a minute and it quits and will not run for a wile then when I try to cranked in cranks easily but one spot is real hard also oil is coming out the new head gasket when I cranked I also have 40 pounds of oil pressure and spark
 
Matt,

It sounds like your rings might be too tight and something could be wrong with the way you installed your oil rings. Were you sure to check the ring gap before you put everything back together? If its that tight, you better take things back apart before you do some real dammage to the inside of your cylinder walls.
 
You must log in or register to reply here.

Similar threads

J
Cummings 5.9L Head Gasket
2
Replies
26
Views
1K
JIM MN
J
E
1950 JD Model A question
Replies
9
Views
733
Mike(NEOhio)
M
J
Case oil filter
Replies
4
Views
213
jhncp
J
grandpa Love
8 volt cub update
Replies
10
Views
621
Fixingfarmer
Fixingfarmer
W
Ford 172 diesel squealing noise, no oil pressure, loose harmonic balancer bolt, and white smoke out of breather
3 4 5
Replies
87
Views
4K
Woodtractor1
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top