(800) 853-2651
SHOP NOW

Liners

A

Anonymous-0

Well-known Member
Hi Guys.
I am getting ready to put a set of used liners in a Farmall H block, I have cleaned the block and the liners, I plan on putting the liners in the freezer over night, do I need to lubricate the block or the liners ? these liners came out of an engine that had a cracked block, the tractor only ran for a couple of hours, I took them out when I brought the tractor, Thank you for any help you can give me.
Ken.
 
When I put new liners in my H I put them in the freezer overnight,didnt put any grease or oil on them and most of them slid right in.One of them was a little tight and I had a block of wood and a hammer and drove it in about half way when it got hung.It went in easy.You wouldnt want to hit them real hard maybe.Also if it acts like its trying to hang you can turn it some and it might go right in.You want to put it right in as quick as you can.Everything has to be clean as you can get it helps too.
 
one of my manuals recommends you spray kerosene in the block bore to act as a lubricant to get the liner in. i have used kerosene and wd40. either works good. could prolly use a lil diesel fuel too.
 
You must log in or register to reply here.

Similar threads

R
To sell or Pitch; STD liner & Piston
Replies
2
Views
473
greg krush
G
T
oliver 88 pistons sleeves
Replies
5
Views
747
VicS
V
M
D-361 C1 Block
Replies
4
Views
421
J.Wondergem
J.Wondergem
Hobo,NC
Freezer drain
Replies
10
Views
760
Hobo,NC
Hobo,NC
S
ford 5000 new engine? Any advice on where to get?
2
Replies
30
Views
2K
sunnyfield
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top