(800) 853-2651
SHOP NOW

Farmall 504 hydraulic issues with loader

T

Timryan0735

New User
I have a Farmall 504 with loader and I can not figure out the hydraulic problems does some one have pictures of the hydraulic lines and where they run to I have the loader hooked up to the front ports if u have both lines hooked up the loader will not go up if u have just the one hooked up it will go up and down just fine but I can t lift more the 500 pounds with it my number is +17018093300 be the best way to get ahold of me
 


Don t honestly thing so have pressure just no clue what s going on it honestly acting like the lines are crossed but there not
 
Can you provide a little more information? Such as, is the tractor and loader new to you or have you had it a while? Did you remove the loader recently? Did it work fine before? What loader is it? Have you tested the pressure of the hydraulics on the tractor?

Honestly it sounds like you have the hoses crossed up. I know you said that they aren't but are you SURE? Sometimes we look at things so many times that we just glance and assume that it's right. Done that a few times with spark plug wires myself.

Many loaders from around the time of the 504 were pressure up gravity down. So there would only be one hose for the boom cylinders. The second hose would go with a third hose and together they would control the bucket tilt.
 
I only had the tractor for about 6 months I got it because the guy that had it was going to scrap it due to head gasket none of the hydraulic where hooked up when I got it s the cylinder on the loader have up and down and had lines running to it I check the lines and rechecked I also had another person check the lines they are not crossed
 
You must log in or register to reply here.

Similar threads

M
  • Question
JD 1020 with 37 Loader
Replies
10
Views
487
used red MN
U
B
Crank Driven Hydraulic Pump Oil
Replies
3
Views
500
Bill VA
B
super99
Oliver loader
Replies
7
Views
273
super99
super99
Mike440i
440i with 71 loader and pippen backhoe
Replies
6
Views
302
Mike440i
Mike440i
J
Advice needed on adding hydraulic remote for quick attach on industrial loader tractor
Replies
10
Views
591
jacks
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top