(800) 853-2651
SHOP NOW

Super C catastrophe

G

gab

Well-known Member
Last Saturday afternoon I took the Super C out to try getting the driveway open. I got it open and was backing in the shed when the right control lever for the touch control hyd got pulled out of my hand. I found a big cotter key tore up on the rockshaft that also destroyed the control operating link.

Looked like junk to me so I went over to the junk yard and got another one. Kind of handy for Farmall parts only about four or five miles away.


cvphoto143947.jpg


cvphoto143948.jpg


cvphoto143949.jpg


cvphoto143950.jpg


cvphoto143951.jpg
 
There used to be 2 tractor yards near us. Now there are none. When I bought this Farmall 460, I did not realize both of the yards had cleaned house. One says they get some parts in every once in a while, but they aren't very cooperative in providing any more information than that!
 
Looks to me like somebody put too long of a cotter key in the rockshaft at one time and didn't get the ends bent good enough,
which looks like a tuff job to do anyway. The key jumped up abought three quarters of an inch and bent the control linkage badly.

I Shure hope the new used one works or the tractor's going to be useless to me.
 
gab, next time you're at the junkyard, pick up one of these for me....
cvphoto144028.jpg


Should be 3/4-16 threads. See my thread further down in Tractor Talk. I'll pay you what its worth, and the shipping. Steve
 
gab, next time you're at the junkyard, pick up one of these tie rod ends for me....
cvphoto144028.jpg


Should fit on 3/4-16 threaded tie rod. See my thread further down in Tractor Talk. I'll pay you what its worth, and the shipping. Steve
 
You must log in or register to reply here.

Similar threads

M
Farmall C/Super C Liftall Differences?
Replies
2
Views
309
Harold Hubbard
H
M
Control Tower Differences - Super C
Replies
2
Views
285
mainer76
M
M
Searching for Super C Shafts
Replies
11
Views
672
Bull Gear
B
C
Tractor project in March - Super C
Replies
3
Views
339
NY 986
N
A
Do I have a Farmall Super C or regular C?
Replies
9
Views
847
Geo-TH,In
Geo-TH,In
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top