(800) 853-2651
SHOP NOW

MF 32 loader repair

M

Massey83

New User
Hi. I have a MF 32 loader on my FE35 and one of the lift cyl's is leaking. Never done a seal replacement before. Watched some youtube, seamed easy enough. Of course, the cyl's on this loader are different than all the youtube examples. I can't figure out how to a: get the shaft out and b: get the seals out. I will try to post pictures. Any advice would be appreciated!

cvphoto136013.jpg


cvphoto136014.jpg


cvphoto136015.jpg
 
The snap ring groove is just catching on the seal rings the groove of the bore in the end nut or cap. Oil or grease up the snap ring groove. Place the cap in the vise so the ram is down towards the floor and the hex is on top of the vise jaws. Hopefully the vise is high enough the ram will not be on the floor. Hopefully you have a large brass drift but if not a short large shaft or big bolt would work in a pinch. You are going to give the end of the ram a good smack with at least a 2 lbs hammer. If you do not have someone to catch the ram and the other end is off the floor quite a bit place a bucket there to catch it with some boards and rags in it.
 
I have used a layer of electrical tape and some grease to ease seals past snap ring grooves, keyways, etc. The tape doesn't seem to add enough diameter to matter and the seal slides over it and the groove with no damage.
 
You must log in or register to reply here.

Similar threads

T
MF 1244 loader
Replies
0
Views
275
terryz
T
S
MF 304 problems
Replies
9
Views
295
SuburbanBen
S
T
Farmall 504 hydraulic issues with loader
Replies
4
Views
259
Timryan0735
T
U
MF 200 Loader Dump Cylinder
Replies
3
Views
265
Used-to-be-iowa-dave
U
C
Hydraulic cylinder on bush hog loader question
Replies
6
Views
394
Copotay
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top