FORD 3000 Wheel Weights

hoosier43fan · Jun 6, 2022

Have some donut wheel weights that appear that they will need to bolt on through round holes (3) through dished hubs, which seem to line up on both pieces. Any tips regarding what type/size fasteners, install or any ideas greatly appreciated.

caterpillar guy · Jun 6, 2022

The biggest bolt that will go through the hole. Then measure the wieght thickness and ad about an inch to inch and a half to that for nut dish nd a washer if needed.

hoosier43fan · Jun 6, 2022

Sounds good thanks.

farmallboy15 · Jun 7, 2022

Besides figuring out what size bolt to fit the hole I
suggest cutting some all-thread to length and welding a
nut to the end if you have more than one weight to stack
on. This allows you to just slip them on vs trying to bolt
one weight to another.

hoosier43fan · Jun 7, 2022

Got it thanks

hoosier43fan · Sep 3, 2022

The weights have two sets of equally spaced three hole mounting configurations. One set is flush mount and one set has an indent into a half circle. Does it matter which are used to flush mount to a smooth rim surface?

FORD 3000 Wheel Weights

hoosier43fan

Member

caterpillar guy

Well-known Member

hoosier43fan

Member

farmallboy15

Member

hoosier43fan

Member

hoosier43fan

Member

Similar threads