hey SV

glennster · Nov 27, 2021

do you think this will pass ytdot? 4 transport chains. 3/8, two
binders and two boomers wired down 53 super m

stoughtonfarmboy · Nov 27, 2021

Rare air cooled engine?

Ken

DeltaRed · Nov 27, 2021

Pedal powered

rustred · Nov 27, 2021

maybe electric experimental.

tractorsam · Nov 27, 2021

Dont you only need two chains for half a tractor?

wore out · Nov 27, 2021

(quoted from post at 08:37:51 11/27/21) Pedal powered

https://i.imgur.com/MVwNbbu.jpg".

.

Adrian Billheimer · Nov 27, 2021

Nope, nothing holding the front down, one good pothole and it'll flip right over, plenty of repower potential though, I have a Super H in pretty much the same condition.

rustred · Nov 27, 2021

it looks tied down good to me. its around the bell housing frame. no way the front can lift.

jm. · Nov 27, 2021

More than 4 ft from that rear chain, technically it would fail the 4 point test, Most scales here IF they went to the trouble to check would demand two chains on the front. All depends on what kind of day the inspector is having.

Rich'sToys · Nov 27, 2021

You could tie that down with a rope and it would hold!

Just kidding!

rustred · Nov 27, 2021

cant call that red machine a green machine, lots of methane gas produced .

SVcummins · Nov 27, 2021

Better ask barney himself .

john in la · Nov 27, 2021

You can legally tie down things with rope.
Problem is you need 30 pieces of rope to do the same work as a good piece of chain.

SVcummins · Nov 27, 2021

Didnt take long for him to show up did it

caterpillar guy · Nov 27, 2021

It's good that way though I would not do it like that. For an old parts machine like that I would just throw one over the frame behind the steering bolster and one through the drawbar and call it good and is legal for old tractors. One chain hooked right will make 2 separate tiedowns and the one in back will also or Just 2 with 2 chains. and screw Barney.

glennster · Nov 27, 2021

its not a parts machine. i have the engine rebuilt at my body shop, new clutch assembly, sheet metal is all done too. will go thru the back half of the tractor this year, i hope.

SVcummins · Nov 27, 2021

Fiat cnh famous for our long torque engines

hey SV

glennster

Well-known Member

stoughtonfarmboy

Member

DeltaRed

Well-known Member

rustred

Well-known Member

tractorsam

Well-known Member

wore out

Well-known Member

Adrian Billheimer

Well-known Member

rustred

Well-known Member

jm.

Well-known Member

Rich'sToys

Well-known Member

rustred

Well-known Member

SVcummins

Well-known Member

john in la

Well-known Member

SVcummins

Well-known Member

caterpillar guy

Well-known Member

glennster

Well-known Member

SVcummins

Well-known Member

Similar threads