kcm.MN
Well-known Member
- Location
- NW Minnesota
- Thread starter kcm.MN
- Start date
OP
OP
kcm.MN
Well-known Member
- Location
- NW Minnesota
Somehow I had a feeling you'd be interested in this. *hehe*
caterpillar guy
Well-known Member
If the front end of the roller frame could be set off the ground just a bit it would turn much easier and still float like tracks do. An inch or 2 would be all it would take. No counter weight needed either.
flying belgian
Well-known Member
Front axle looks like a 4620 yes?
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy