Minneapolis-moline jet star 3 help

hello tractor people, I have purchased a jetstar3 industrial tractor with a backhoe and front loader, out of Pennsylvania back in March and had it shipped to Kansas. I got it running which was a great start for me. I recently discovered it needed a clutch and with the help of this forum I found the parts I needed and support to completed this job also, outside if I may add. Now when I split this tractor I had to disconnect the four power steering lines that run horizontally along side the left hand side of this tractor, and yes I marked them, BUT being outside, my marking have faded to a point that only one is connected right. I attempted to put the other three back but when I started t the tractor the steering wheel turned by it self hard left. I shut the tractor off and changed lines 2 & 3. when I started the tractor the steering wheel spun hard right, I have now damaged something in the steering column, Any help, pictures directions would be appreciated, This is a project, but I am wearing down. please help if possible. two lines go to a reservoir cannister and I believe the other to go to the front of the tractor to the steering gear box.

I replaced the clutch on my Jetstar 3 a few months ago, but I only disconnected the two lines that go to the front.
They both come out of the front of a junction box under the gas tank
The one on the right (if youre in the seat) connects to the upper line, the left one to the lower line
Two lines from the top of the box go up to the steering wheel
If you send me your email address, I should be able to send a picture

(quoted from post at 14:50:50 09/19/21) I replaced the clutch on my Jetstar 3 a few months ago, but I only disconnected the two lines that go to the front.
They both come out of the front of a junction box under the gas tank
The one on the right (if youre in the seat) connects to the upper line, the left one to the lower line
Two lines from the top of the box go up to the steering wheel
If you send me your email address, I should be able to send a picture

Click to expand...

I finally got the lines figured out, the tractors turns in each directions now, but the steering wheel feels different now, rougher, when the lines were wrong could it really damage anything????, or am I just being sensitive. new to the tractor life, any respose will be appreicated.

You may still have some air bubbles in the lines