kcm.MN
Well-known Member
- Location
- NW Minnesota
- Thread starter kcm.MN
- Start date
Bruce from Can.
Well-known Member
- Location
- Woodville, Ontario, Canada
Either an attempt at abstract art, or dropped a can of paint .
Probably didnt like working in the paint department before,
now hates the job
Probably didnt like working in the paint department before,
now hates the job
Fawteen
Well-known Member
- Location
- Downeast Maine
BTDT, not quite as disastrous.
When I worked at the lumber yard/hardware place, a customer brought in a can of paint and wanted me to shake it up for her.
Didn't check over the can before placing it in the shaker, just tapped the lid to make sure it was on tight.
Bottom was rusted out, took me a couple of hours to clean out the shaker cabinet.
When I worked at the lumber yard/hardware place, a customer brought in a can of paint and wanted me to shake it up for her.
Didn't check over the can before placing it in the shaker, just tapped the lid to make sure it was on tight.
Bottom was rusted out, took me a couple of hours to clean out the shaker cabinet.
When I was in college we had a vibration simulator in the lab. We were testing a dish soap package system and discovered the resonance frequency. Before we got it shut down there was dish soap everywhere. You would think dish soap would be an easy clean up. Its not and do not add water.
Tgrasher
Well-known Member
- Location
- South Southern illinois
I hope it's latex paint because I can speak from experience, enamel is hard to get off.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy