elibowen1959
New User
rebuilding a c123 farmall gas engine rod bearings are stamped .060 unable to locate a replacement set, looking for a direction to get set
- Thread starter elibowen1959
- Start date
Janicholson
Well-known Member
It is very unlikely that you will find a set for bearing journals ground undersized to that extent. Rather than finding a very rare product,
look for a good used crank, they are plentiful. Jim
look for a good used crank, they are plentiful. Jim
Steve@Advance
Well-known Member
Might give this site parts department a call. I don't see a listing but they may have a source.
You can buy a "crank kit", it is a reground crank complete with the correct size bearings. A crank that is ground .060" is past it's service life, asking for trouble trying to reuse it.
If any of the old bearings spun, the rods can be reconditioned, or the mains align bored.
You can buy a "crank kit", it is a reground crank complete with the correct size bearings. A crank that is ground .060" is past it's service life, asking for trouble trying to reuse it.
If any of the old bearings spun, the rods can be reconditioned, or the mains align bored.
teddy52food
Well-known Member
Did you mike the crank? They used to make a .060 semi that was a heavy coat of
Babbitt & then cut it to .020, 030, .040 etc.
Babbitt & then cut it to .020, 030, .040 etc.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy