(800) 853-2651
SHOP NOW

10006 Deutz

T

teddy52food

Well-known Member
Had the inj. pump redone. Now I have fuel up to the injectors, but the way the lines connect I am sure there is still air in them. Starter spins it over good but I get no smoke from the exhaust. Will that air compress enough to crack the injector? What if they are stuck, will it hurt the pump if I continue cranking? Tractor ran last in 2012.
 
Hurting the starter motor is more likely. Make sure the pump is getting diesel, the loosen all injectors at the injector. Crank for no more than 20 seconds (fuel set to max or start if it has that position. Let it rest for 2 minutes, then 30 seconds again. Might need the charger on it. repeat until the diesel comes out of the loose connection. then tighten each as they leak. It might start! if it does tighten the remaining injector lines as fuel appears. It will not compress air to pop the injectors. Jim
 
Messed with it for quite a while with no smoke. Took one injector out & hooked it up to the line. Spun it over & no spray from the tip. I pulled them all & will need to get them unstuck. Is this something I can try myself?
 
I got one apart & the pintle was stuck. Had to gently heat it with propane & when the wax melted, it slid apart too. Cleaned it all up & it was free to move. Put it all together & will have it pop tested before I install it.
 
You must log in or register to reply here.

Similar threads

S
MF40 Industrial won’t start after 12 years
2
Replies
39
Views
1K
Dieseltech
D
4
Ford 2310 white smoke
Replies
7
Views
257
Texasmark
T
F
Followup question on CAV injector pump - trying to get i
Replies
2
Views
237
Dieseltech
D
K
480 ck backhoe
Replies
6
Views
305
used red MN
U
M
Ford 555c air out of the injector pump
Replies
5
Views
259
mic-t
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top