Talked to a scrap dealer today he is paying 200.00 per ton for prepared steel, starters he said are .25 cents a pound , That means a 42mt starter would be about 13.00 bucks, what is scrap in your area, but he also said it will go down in FEB.. Mississippi coast here
Re: OT Scrap metal in reply to farmer656, 01-13-2021 18:30:45
$180 ton and $200 12 miles away at yards belonging to same people. Guess it just depend's on what the market will bare. One consulation for me is they sell me anything I want for what they get when they sell to processors. It work's out well when I pay $50 for angle,plate and pipe that would cost far more for drops at the steel yards.
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.