Today's funny

jon f mn · Nov 9, 2020

.

Larry EC-OH · Nov 9, 2020

BYDT...
Followed by a string of explatives
Then the work of fixin' it

Thanks Jon. I needed a smile this morning.

Glad you got the corn out.

Larry

fastfarmall · Nov 9, 2020

With the new high powered air wrench's, it can happen pretty quick !!!

super99 · Nov 9, 2020

I just did that last week and I didn’t even have a impact on it. I guess I don’t know my own strength!!!!

JMOR · Nov 9, 2020

Never was funny when I was holding the tools!

gajack · Nov 9, 2020

Had My Nephew putting motor mounts oh his Jeep.
BIG KID, ok Mike, once you get the nut started make sure its tight. Sure enough tighten it up till it broke the stud off the New motor mount.
Good luck to all, gajack

Goose · Nov 9, 2020

You got that right!

A year ago, I bought a Ryobi cordless impact wrench. It's rated at 300 ftlbs I said when I bought it I wouldn't expect it to compete with my 1200 ftlb air impact. The truth be told, I haven't even used an air impact since I got the cordless one.

john in la · Nov 9, 2020

Work with a aluminum block often enough and you will learn to use a torque wrench on every bolt.
Then you add a little salt water to the mix and you will learn to put grease on the threads before you put the bolt in.

grizz02 · Nov 9, 2020

BTDT , or when you thought you had the impact in reverse and snaped bolts off

tomtinker · Nov 9, 2020

I always try to take my old pappy's advice and stop right before it snaps. Lol.

Terry G · Nov 9, 2020

Tighten it till it strips then back it off a quarter turn,

Today's funny

jon f mn

Well-known Member

Larry EC-OH

Member

fastfarmall

Well-known Member

super99

Well-known Member

JMOR

Well-known Member

gajack

Member

Goose

Well-known Member

john in la

Well-known Member

grizz02

Well-known Member

tomtinker

Member

Terry G

Member

Similar threads