PTO Lever Mod

rusty6 · Jun 25, 2020

I thought I posted this video link earlier today but can't seem to find it on the forum so here it is again. Its a modification I made to the pto engagement
system on my 2090 Case. Cheap, crude and nothing fancy but its an improvement on the factory setup for sure.
Pto lever mod

SVcummins · Jun 25, 2020

Pretty good job there . I thought about putting my duals on to spray but didn’t get around to it maybe try it if I go after more brush this fall

rusty6 · Jun 25, 2020

(quoted from post at 21:10:01 06/25/20) Pretty good job there . I thought about putting my duals on to spray but didn t get around to it maybe try it if I go after more brush this fall

I'd have been fine without duals for spraying this year but I still had them on from earlier when I was pulling the packer harrow. And for that job I want duals on the tractor. Went without last spring and got stuck. I'll be taking them off tomorrow since I finished in crop spraying tonight and hope to hitch up to the haybine and cut a bit of hay.

Bruce from Can. · Jun 26, 2020

That was a good fix !!

SVcummins · Jun 27, 2020

I’ve thought about putting the duals on so you don’t pack the
grain down as bad before these new row crop sprayers got
popular all the grain was sprayed with three wheelers we’ve
we have had them spray grain that was headed out with 3
wheelers .

PTO Lever Mod

rusty6

Well-known Member

SVcummins

Well-known Member

rusty6

Well-known Member

Bruce from Can.

Well-known Member

SVcummins

Well-known Member

Similar threads