(800) 853-2651
SHOP NOW

5065E John Deere problems

H

Hayguy11

New User
I recently purchased a used John Deere 5065 E. It says it only has 575 hours. It came from Texas. The tachometer has stopped working. And suggestions?
 
Not enough information to tell you very much. I assume the tach is electrically driven. If you are worried about actual hours, there is no way to get
that information unless you discuss it with the prior owner, and he/she is truthful. Looking at wear on foot pedals, 3pt hitch wear at lift points and
drawbar primary hole, throttle lever looseness, tire condition, and belt wear would be indicators. That few hours will show very little wear in those
areas. If those are worn, then suspect many more hours.
If fixing the tach is intended, testing the wires end to end for continuity, and connections at the sending ans tach ends is a start. A signal tracing
pulse detector (electronic hand held meter) can be a crisp solution to analysis. Pulses to tach, it is the tach that is bad. Jim
 
(quoted from post at 19:49:19 04/16/20) Not enough information to tell you very much. I assume the tach is electrically driven. If you are worried about actual hours, there is no way to get
that information unless you discuss it with the prior owner, and he/she is truthful. Looking at wear on foot pedals, 3pt hitch wear at lift points and
drawbar primary hole, throttle lever looseness, tire condition, and belt wear would be indicators. That few hours will show very little wear in those
areas. If those are worn, then suspect many more hours.
If fixing the tach is intended, testing the wires end to end for continuity, and connections at the sending ans tach ends is a start. A signal tracing
pulse detector (electronic hand held meter) can be a crisp solution to analysis. Pulses to tach, it is the tach that is bad. Jim
Click to expand...
hanks for the info
 

Hayguy11
Welcome to YT. Check electrical connection at sensor on LH frt of engine & connections at back of instrument panel & panel ground connection.
 
You must log in or register to reply here.

Similar threads

T
John Deere 5075en
Replies
3
Views
218
Tyler2240
T
F
John Deere 8440 reverse not working
Replies
2
Views
189
wore out
wore out
O
Johndeere 410B 4x4 backhoe wont start since last fall 2023. I have changed fuel filter, manual fuel pump, checked fuel solenoid visibly
Replies
6
Views
381
37chief
3
B
John Deere 2020 PTO Clutch Adjustment
Replies
13
Views
550
Tx Jim
Tx Jim
P
John Deere 330 Dimensions
Replies
11
Views
618
Jim.ME
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top