Fawteen
Well-known Member
- Location
- Downeast Maine
All done. It was a fun project, not nearly as fussy as I expected.
- Thread starter Fawteen
- Start date
OP
OP
Fawteen
Well-known Member
- Location
- Downeast Maine
Nope, built from scratch using sheet plastic and some plastic tubing. Evergreen makes about anything you could want for modeling in plastic.
greenmech
Well-known Member
- Location
- Lakeville MN
Nice work. I can't see the zerks though. Ron MN
OP
OP
Fawteen
Well-known Member
- Location
- Downeast Maine
I might be. I'd need pictures and measurements.
OP
OP
Fawteen
Well-known Member
- Location
- Downeast Maine
Good question. Pretty much everything is available commercially, I built this because I couldn't find ANY pull-type combines in 1:64
AC Roto Baler has been suggested, but we had one and it was a miserable SOB, no interest in reviving THAT memory!
AC Roto Baler has been suggested, but we had one and it was a miserable SOB, no interest in reviving THAT memory!
OP
OP
Fawteen
Well-known Member
- Location
- Downeast Maine
Harder, but possibly doable. I'd need to know the scale of the combine and see some measurements. A little math would let me scale it down to 1:64 with reasonable accuracy.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy