Line Brackets

SVcummins · Dec 28, 2019

Fired up the old miller and welded a couple
brackets on today . I?m going to weld two more on a
littler further down the frame . Originally farmhand
Just had some flat stock welded in a few spots
along the frame then ran the lines through and
folded the tabs over

Ellis Kinney · Dec 28, 2019

I have used those very same brackets several times. They are the best you can buy. Ellis

SVcummins · Dec 28, 2019

Somewhere in my internet searching I found some that hold 4 lines each I cannot find them ever again

37chief · Dec 29, 2019

That should do the job. How did you keep from striking an arc on the lines? Stan

RBMI · Dec 29, 2019

Those look like ZSi-Foster clamps. I buy them through my local Parker store. They usually don?t have much in stock, but if I need them fast, I can pick them up at ZSi?s facility in Canton, MI.

SVcummins · Dec 31, 2019

Without the clamps the lines aren?t any where near the welding because they have rubber on both ends

SVcummins · Dec 31, 2019

Rbmi these are Taiwanese and have an H stamped into them

Line Brackets

SVcummins

Well-known Member

Ellis Kinney

Well-known Member

SVcummins

Well-known Member

37chief

Well-known Member

RBMI

Member

SVcummins

Well-known Member

SVcummins

Well-known Member

Similar threads