Little tedder repair

Olliejunkie

Well-known Member
I bought this tedder awhile back. The landing gear was broke on one side and the other wheel was ran flat until the rim was all bent up. I bought some new wheels and tires. A friend turned me out some new spindles. I welded it all up today. Hoping I can get it sold now.
mvphoto37190.jpg


mvphoto37191.jpg
 
You are just like me, get it all fixed up and put it up for sale, what the heck?
 
(quoted from post at 22:24:32 06/04/19) You are just like me, get it all fixed up and put it up for sale, what the heck?
Yea Bob. I dont like tedder rakes much mainly because I usually rake two rows together. They're nice though cuz you can pick up the 3 point and go.
Jd seller it is a tedder rake. I'm not much of a welder but I think with the new design it will hold up. I mainly did it that way cuz I already had the square tube cut to length.
 
(quoted from post at 03:04:54 06/05/19) Nice job! Should hold up real
well.
Thanks Jon. I think its probably stronger than new. I have really fought with this Clarke welder on light stuff. It worked pretty good on heavier metal. My biggest problem is I'm not very steady and cant see anymore. Could've used a better bench too. I wont show close ups of my welds.
I dont think it will get off the ground Showcrop. Maybe if I change out the tines with props.
 
(quoted from post at 06:30:40 06/05/19)
(quoted from post at 03:04:54 06/05/19) Nice job! Should hold up real
well.
Thanks Jon. I think its probably stronger than new. I have really fought with this Clarke welder on light stuff. It worked pretty good on heavier metal. My biggest problem is I'm not very steady and cant see anymore. Could've used a better bench too. I wont show close ups of my welds.
I dont think it will get off the ground Showcrop. Maybe if I change out the tines with props.

Oh, OK, landing gear makes it sound like it is going to land.
 
(quoted from post at 13:00:47 06/05/19)
(quoted from post at 06:30:40 06/05/19)
(quoted from post at 03:04:54 06/05/19) Nice job! Should hold up real
well.
Thanks Jon. I think its probably stronger than new. I have really fought with this Clarke welder on light stuff. It worked pretty good on heavier metal. My biggest problem is I'm not very steady and cant see anymore. Could've used a better bench too. I wont show close ups of my welds.
I dont think it will get off the ground Showcrop. Maybe if I change out the tines with props.

Oh, OK, landing gear makes it sound like it is going to land.
I think the last guy brought it in for a crash landing. The one wheel that is left is star shaped.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top