truckfarmer49
Member
I'm in a pinch.
I need to remove a pitman arm Again for a Second Time that I Already removed a few weeks ago.
The trouble is, this time round has been way harder!.
Lots of heat from torch, using same puller as last time, but no budging. Plenty of PB too...
My current plan is to find a better puller.
Any suggestions?
(I greased the sector shaft and then used too much torque upon reinstallation)
I need to remove a pitman arm Again for a Second Time that I Already removed a few weeks ago.
The trouble is, this time round has been way harder!.
Lots of heat from torch, using same puller as last time, but no budging. Plenty of PB too...
My current plan is to find a better puller.
Any suggestions?
(I greased the sector shaft and then used too much torque upon reinstallation)