I have a vane type hyd pump for my 730 loader that I replaced the spline shaft,seal and bearing. I took pictures as I disassembled it to guide me in reassembling it. Back together and filled with fluid. I cracked the out put line and I have fluid to that point. I get no response. I did get a belch back through the breather one time. Any guidance would be appreciated.
- Thread starter Tiber56
- Start date
Destroked 450
Well-known Member
- Location
- Harned, Ky
No sure about the pump you have but on some vane pumps if you turn the center body around it'll pump in the other direction.
Are you sure you got it back together exactly like it came apart.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy