450 case dozer

fidoredman · Feb 21, 2019

How can I get a video of repairing brake on the 45case

JohnV2000 · Feb 21, 2019

(quoted from post at 16:39:17 02/21/19) How can I get a video of repairing brake on the 45case

Try YouTube, but other than that, I am not sure. If there is no video, a service manual will do a pretty good job.

marloweg · Feb 21, 2019

if brake are not working first off you DON"T need them but if you want them it will be the master brake cylinders that are shot 2 cylinders one for each side pain to get at under floor board pull them out and get part number off the and go to napa NOT case dealer . then when you get them pull the cap off and rubber boot out and poke a pin hole in it they MUST HAVE A VENT OR THEY WILL BUILD UP PRESSURE FROM THE HEAT don't ask why just do it if you don't the clutches will start to slip after about a hour of working the machine . bottom line is you don't need the brakes they were NOT made for turning while working the machine

marloweg · Feb 21, 2019

p.s good luck finding cylinders last ones i changed Case could not get and Napa looked high and low core charge was like 75.00 each 10 years ago .bottom line you don't need them just make sure your hand brake works

450 case dozer

fidoredman

New User

JohnV2000

Member

marloweg

Well-known Member

marloweg

Well-known Member

Similar threads