(800) 853-2651
SHOP NOW

Spindle on a commercial zero turn---CUB TANK

L

lenray

Well-known Member
Have this heavy duty commercial zero turn mower. It is the Tank by Cub. 24 HP Honda.
There is a part missing off the spindle for the blade. From the bottom up there is a big nut--the blade-a spacer----above the spacer and below the bearing there is a round part missing. Guessing it is a seal for maybe keeping out dirt on the bearing. Was told that this part is not available---you have to buy the complete spindle- bearing etc. as a set.
Any of you folks have any info. on this. 2003 low hour model.. thanks
 
Does it exist on the other two spindles ?

Not shown here:
mvphoto19004.jpg
 
If not on the other spindles, it may be the result of plastic twine wrapping around and melting from the heat. Makes pretty washers, but not original equipment.

Happens with disk mowers/mowerconditioners on the ag equipement.
 
You most likely will break a bolt trying to take the spindles off to replace it, if you take it off. Which Deck do you have? I might have an old spindle from when I changed the deck on my 50.
 
Had that a couple of days ago after picking up a hunk of plastic baler twine. What a mess getting that out. Actually slowed the engine and your brain goes oh not again!
 
Yes the other spindles have it....It may be a 1/4 inch thick--what ever it is. It looks like a round gasket pressed up above the spacer and it rotates with the turning of the blade. Thanks for the pic................
 
It appears the spacer holds it in place. Probably fell out on a blade change sometime prior. It looks like dirt could get up in there with out this gasket........
 
You must log in or register to reply here.

Similar threads

L
CUB CADET TANK COMMERCIAL ZERO TURN MOWER
Replies
7
Views
291
J Hamilton
J Hamilton
D
1020 Front spindle Snapped!
2
Replies
26
Views
1K
Fixingfarmer
Fixingfarmer
K
Case J44 mower deck
Replies
0
Views
554
kevinstuff
K
W
Work on the narrow front WD steering continues...
Replies
0
Views
264
Will Herring
W
I
Lilliston 7-six spindle info
Replies
1
Views
470
navy guy
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top