JD 24t roller dog clicking

Bkpigs · May 28, 2018

The roller trip dog is hitting the cam lobe on the knotter drive. It isn't enough to make it cycle through a knot but enough to make noise. Just looking quickly I don't see an adjustment for this. Am I missing something? The bushings for the bale length measurer don't seem to worn either.

Thanks in advance!

Tx Jim · May 28, 2018

Is there any grease inside sprocket where trip dog roller contacts cam lobe? If so remove the grease

Bkpigs · May 28, 2018

No, inside the sprocket area is clean. I was able to move the bale length measurer back a little and it is just far enough that the arm will fall freely when the knotter is tripped. But, the roller will just hit the high spot on the cam. It is much better but still not completely clear.

JD 24t roller dog clicking

Bkpigs

Member

Tx Jim

Well-known Member

Bkpigs

Member

Similar threads