Super A Light Switch

HVFDfirefighter · Aug 10, 2017

Attached is a photo of the back of my three position (CDB) ligh switch.

Is this correct:
1 goes to leg of fuse, other leg of fuse goes to ammeter
2 goes to rear light
3 goes to headlights

If I wanted to add a panel light, which terminal of the light switch would I connect the positive side of the light to?

Thanks for the help!

Janicholson · Aug 10, 2017

Looks correct. If you want panel lights to dim and brighten with the headlights, put them on the headlight screw. If you want them
to stay bright, put them on the tail light screw. Clean and brighten all terminal surfaces and under the screw heads, or new
screws. Some clear acrylic spray can help keep things from rusting. Jim

gene bender · Aug 10, 2017

You said positive side of the lite isnt the system postive ground.

HVFDfirefighter · Aug 11, 2017

(quoted from post at 20:14:33 08/10/17) You said positive side of the lite isnt the system postive ground.

Sorry did not say, tractor had been converted to 12 volt negative ground.

Super A Light Switch

HVFDfirefighter

Member

Janicholson

Well-known Member

gene bender

Well-known Member

HVFDfirefighter

Member

Similar threads