Found my pressure washer - Thanks guys!

Lanse · Mar 21, 2016

So a little while back I asked on here for advice on buying a pressure washer. I was looking for what I should get pump wise and whatever else folks thought I should know, and I just ordered what you see in the picture. Its american "assembled" (lol), has the CAT pump that everyone says is the best, and the Honda commercial engine that I wanted. It was also only $2-$300 more than the consumer grade flimsy pressure washer specials that I've seen in various big box stores, and now its on the way to my shop!

Thanks again guys! I'm pretty excited about this, now I just have to figure out how to make proper use of this beast!!

Screen%20Shot%202016-03-21%20at%203.18.19%20PM_zpspphvsxft.png

Patsdeere · Mar 21, 2016

One thing I can say is when you replace the tips, make sure you use the proper size (not the angle, but the actual size is critical to pump capacity). Too small will cause the relief valve to constantly stay partially open causing it to prematurely fail. BTDT.

fixerupper · Mar 21, 2016

You will love it.

fixerupper · Mar 21, 2016

Oh, another thing, when it comes get a few Orings for the tip. It's nice to have them on hand. Seems like I go through an Oring a month but maybe it's because I use hot water.

bill mart · Mar 21, 2016

if you don't keep it in a heated shop and it gets below freezing read and follow the directions on how to winterize it. Bill

Found my pressure washer - Thanks guys!

Lanse

Well-known Member

Patsdeere

Well-known Member

fixerupper

Well-known Member

fixerupper

Well-known Member

bill mart

Well-known Member

Similar threads