(800) 853-2651
SHOP NOW

2016 tractor project progerss

A

Adirondack case guy

Well-known Member
Well the Case 931 is all torn apart and parts have been ordered. Should be at my parts suppliers place by end of week. We have three great parts suppliers on the Case forum that quickly provide new and used parts at reasonable prices. I fabed up a stand to support the tractor, and a bracket to lift the block with the cherry picker.
Yesterday I got the cab in the shop so I can start refurbishing that, plus I drove the 440 in to fix a generator problem, and finish the wireing for the lights on the cab I built for it. The shop is getting a bit crowded. with 3 tractors and a small dozer in it, plus the front end and cab of the 931 taking up floor space.
Loren
a211777.jpg

a211779.jpg

a211781.jpg

a211783.jpg

a211784.jpg

a211785.jpg

a211786.jpg

a211788.jpg
 
I have a Royall wood/coal boiler in the shop. It heats the whole house and full walkin celler plus the shop very nicely. Back in 1992 I tore out our old forced air system and designed and installed a whole house radiant floor heating system. Five years ago, I took the Royall boiler out of my dads house after he died, and installed it in my shop and hooked it to my radiant system, along with a solar hot water system which supplies our domestic hot water also. We haven't burned a drop of heating oil in 5 years. There is a unit heater suspended between the overhead doors in the shop which I turn on during the days. The boiler puts off some ambient heat, and once I have the floor and all the steel warmed up in the shop, the temp remains very constant.
Loren
a211807.jpg
 
I had one of those Royal stoves for about 25 years and they are well built, didn't know they still made them.
 
You must log in or register to reply here.

Similar threads

J
I Harp & Harp But It Happened Again!!
2
Replies
25
Views
2K
cushman
C
D
1020 Front spindle Snapped!
2
Replies
26
Views
1K
Fixingfarmer
Fixingfarmer
J
Allis B project
Replies
0
Views
318
Jeff B.
J
J
Allis B project
Replies
4
Views
719
mrhud
M
S
Good quality Ford tractor, easy to find Ford parts?
Replies
4
Views
1K
Sally mae
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top