(800) 853-2651
SHOP NOW

PTO seal on 1967 Ford 2000

M

midgainc

New User
This message is a reply to an archived post by Ultradog MN on July 10, 2009 at 20:05:30.
The original subject was "Re: PTO seal on 1967 Ford 2000".

I also have a 67 with a leaking PTO seal. Did you do this repair yourself? How long did it take?

My tractor is also leaking from the clutch and brake pivot rod on the lower side of trans/differential. Looks like I will be tackling that job also.

Thanks.
 
Both are easy. Especially if you don't have a loader on. Do them at the same time so you don't have to drain oil twice. Cross shaft, take the pedals off. Slide shaft to one side, pop the seal out of the other side. Slide shaft the other way and do the same. Don't forget to get the felt dust seals when you get the rubber seals. I just did mine. Have a loader on mine so I had to work around the arms. Pto, the hard part for me was getting the shaft out. Had to use a slide hammer. Actually, a loop of chain with a bolt through the hole in shaft and a 6 lb hammer as a slide. Don't remember which way, engaged or not.
Maybe 3 hrs for both.
 
I will be ordering the parts for both today. Thanks for the help.

I also want to fix the shifter so that third and reverse do not get tangled so easily. Any tips on that?
 
You must log in or register to reply here.

Similar threads

B
Ford 2000 PTO shaft seal leaking
Replies
2
Views
135
Bennett French
B
U
960 PTO Seal Replacement
Replies
1
Views
154
TomIn
T
J
Where buy flexible PTO Shaft for Cyclone Spreader?
Replies
6
Views
270
VicS
V
W
871 PTO output seal replacement
Replies
5
Views
202
Ultradog MN
Ultradog MN
K
Mounting Hiniker 1300 on JD3020
Replies
5
Views
391
rbeissel
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top