Back on the MH44

David G · Mar 8, 2014

I got the hubs put back together today with new bearings and seals. One hub was totally shot, so I took another off an old NF I had.

I am going to get the new spindle bushings in this week, then work on tie rods.

Janicholson · Mar 8, 2014

It will be very nice when still not quite done (a normal condition). Jim

David G · Mar 8, 2014

I had a bugger finding spindle bushings that would fit. It is nice to get back on it. The WF was completely shot. I am this far into it, so might as well finish.

I cut firewood for a couple of hours this afternoon and plan to shot bow on 3D targets for a couple of hours tomorrow.

88-1175 · Mar 8, 2014

david ive been following the f/I and elec/ign post,did you happen to do a few dyno pulls for a b/a power gain

Janicholson · Mar 8, 2014

28" on the flats here, with head high piles. Jim

Back on the MH44

David G

Well-known Member

Janicholson

Well-known Member

David G

Well-known Member

88-1175

Member

Janicholson

Well-known Member

Similar threads