Hyd cly help

Anonymous-0 · Jan 11, 2014

I have a new holland 630 rd baler the seals are leaking there is an Allen set screw on side how do I get the ram etc out I don't see snap ring etc. so how does it come out

Allan in NE · Jan 11, 2014

Thee allen screw holds the plug.

Remove the screw, then push in on the plug and take out the retainer ring on the inside of the cylinder.

Allan

Andy C · Jan 11, 2014

Are there slots or recessed holes on the face of the plug that holds the seal? If so, and the set screw is on the side of the cylinder, then the set screw probably keys the plug. If so remove the set screw and unscrew the plug out of the end of the cylinder with the appropriate tool. (spanner wrench or hammer & punch) If you are beating on it be careful to stay away from the threads of the cylinder.
Good Luck,
Andy

Anonymous-0 · Jan 11, 2014

I found a snap ring looks like a 9 wire there's not enough room to fit it out between plug and cyd wall does the plug push In then take out 9 wire ring pull ram rod out. There's one Allen set screw on the side. I've done lots of cyd never one like this

Allan in NE · Jan 11, 2014

Push the plug "into" the cylinder, then fish out the ring.

Allan

Bradiniowa · Jan 11, 2014

One of the most useful things on those cylinders is an air hammer. Just take your time and watch where you are hitting it.

Anonymous-0 · Jan 11, 2014

Got it I saw early post had to push plug in take out ring I'll it all out thanks

Hyd cly help

Anonymous-0

Well-known Member

Allan in NE

Well-known Member

Andy C

Member

Anonymous-0

Well-known Member

Allan in NE

Well-known Member

Bradiniowa

Member

Anonymous-0

Well-known Member

Similar threads