3020 swap with a problem

RBnSC · Jan 9, 2014

These are pictures of the pulley and yoke that we modified. This is the 3020 with the engine out and the 4 and six cylinder engine on the ground. Problem we have come up against is a pilot bearing. Does anyone know what pilot bearing we need to use?
Ron

Frank 41 · Jan 9, 2014

Will it be a little hard to put the fan belt on?

chuck from neb · Jan 9, 2014

It has to fit on the clutch shaft of the 3020 to begin with and then into the crank ..measure that with a micrometer

RBnSC · Jan 9, 2014

Not as bad as it was.
Ron

Tx Jim · Jan 10, 2014

(quoted from post at 17:20:26 01/09/14) Problem we have come up against is a pilot bearing. Does anyone know what pilot bearing we need to use? Ron

JD9449 should fit as it used for a 4230 powershift & 3020 syncro-range

3020 swap with a problem

RBnSC

Well-known Member

Frank 41

Member

chuck from neb

Member

RBnSC

Well-known Member

Tx Jim

Well-known Member

Similar threads