orc

Kenfarmall · Sep 17, 2013

Hi Guys.
I posted a message this morning about taking off an over riding clutch, I took the roll pin out I have used penertrating oil, I have beat on the shaft with a block of wood but cannot get it to move, do you have any more suggestions any help would be appreciated. ken

old-9 · Sep 17, 2013

I had to cut one off of my 39 Ford. I used a 4 1/2 inch grinder with a cutoff wheel. Took my time. The shaft was (maybe) twisted, dressed it up with a file. It would work ok, but is now a trailor Queen.
Wish you luck.. joe

mj · Sep 19, 2013

Try a slip-hammer with a stout hook on the business end; maybe a [b:01c220a3ef]WEE[/b:01c220a3ef] bit of heat would help :roll:

orc

Kenfarmall

Member

old-9

Well-known Member

mj

Well-known Member

Similar threads