Anonymous-0
Well-known Member
i tried using the bolts instead of the rivets on the knife sections but the boltheads are to high to go underneath the hold down clamps. what do i do now. RICK
- Thread starter Anonymous-0
- Start date
There are two different lenghts of bolt for those. The long ones go through the extra bar for the drive head. On the rest of them,the bolts are barely long enough to have a couple of threads through the nut. If it was me,I'd get the right bolts for replacements,but since those long ones are already in there,I'd take the angle grinder and shorten them up.
When you go to the bolts on the sections you need a high arch hold down too. The ones back by the knife head are even taller than the others so you need two different high arch hold downs. Usually one one or two of the real tall ones.
I personally do not like the bolt on sections for hay mowing equipment because of the higher hold downs. They catch grass and do not mow as well in tough mowing conditions.
I personally do not like the bolt on sections for hay mowing equipment because of the higher hold downs. They catch grass and do not mow as well in tough mowing conditions.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy