chris meredith
Member
witch would you buy anyone had any good luck with a mccormick
- Thread starter chris meredith
- Start date
A friend of mine has a Mccormick 120 and has had some problems with it, don't remember what they were, but caused him pain as we are about 200 miles from a dealer. A neighbour has had 4 JD 6400-6410 tractors and they have put up with an incredible amount of abuse. He is rough on equipment and almost never does preventative maintenance. The 1st one make 15000 hours before it needed an overhaul, then burnt 2000 hours later due to dust buildup, the second one burnt at 10000 hours because he didn't blow 3 inches of grain dust off it, the third just went in the shop at about 20000 hours, and the fourth he has only had for about 2 years, so it is still good.
However, the JD 6210 is only about 66 HP and the Mccormick should be about 80HP. Also, which dealer do you want to deal with because they all break sooner or later. If my friend had bought a JD or Case IH he would have had dealer support right here instead of far away.
However, the JD 6210 is only about 66 HP and the Mccormick should be about 80HP. Also, which dealer do you want to deal with because they all break sooner or later. If my friend had bought a JD or Case IH he would have had dealer support right here instead of far away.
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
John Deere 6210 Power:
Engine: 90 hp [67.1 kW]
PTO (claimed): 72 hp [53.7 kW]
McCormick Intl CX105 Power:
Engine (net): 102 hp [76.1 kW]
Engine: 102 hp [76.1 kW]
PTO (claimed): 83 hp [61.9 kW]
Drawbar (tested): 74 hp [55.2 kW]
PTO (tested): 86.2 hp [64.3 kW]
Engine: 90 hp [67.1 kW]
PTO (claimed): 72 hp [53.7 kW]
McCormick Intl CX105 Power:
Engine (net): 102 hp [76.1 kW]
Engine: 102 hp [76.1 kW]
PTO (claimed): 83 hp [61.9 kW]
Drawbar (tested): 74 hp [55.2 kW]
PTO (tested): 86.2 hp [64.3 kW]
495man
Well-known Member
Both are good tractors...I'd take either.
I am a fan of the CX tractors since the CIH days, but the challenge on McCormick is ensuring you have parts supply, the early CX McCormick were identical to Case IH so most parts should fit, but the later CX McCormick (i.e. Xtrashift) aren't 100% the same...
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy