HanknotFrank
Member
I have been working on deceased father in law's tractor for about 3 months now and have learned a lot, mostly from you guys. Rewired it, new alternator and 12 volt conversion coil. Changed some gages, drained and refilled transmission fluid, adjusted clutch and have had good results, mostly. My new issue is the transmission shifting nicely when not running but hard to shift or even grinding when running. I read about rust problems on shift rails and also rusty, stuck clutches. Any thoughts or guidance would be greatly appreciated. I must have run out of letters in my title. It's a 1953 Golden Jubilee.
This post was edited by HanknotFrank on 10/22/2023 at 06:28 am.
This post was edited by HanknotFrank on 10/22/2023 at 06:28 am.